Products

OTC Ford Master Cam Tool Kit allows the technician to adjust cam timing on any Ford car or truck that has a timing chain or timing belt This kit c...

The Ford Cam Tool Kit Update contains 18 tools, with case locations for addition of the popular 6489 Ford Cam Tools, making a 6690 Kit Ford Cam To...

Oversized retaining plates lock camshafts together at top dead center (TDC) on General Motors 2.8L 3.0L and 3.6L DOHC engines Three-plate set is u...

Works on 1998–newer Ford F-250, F-350, F-450, and F-550 4X4s having the vacuum-operated front axle. Correctly installs the seal onto the axle shaf...

Correctly installs the seal onto the axle shaft and into the wheel knuckle, preventing front hub vacuum leaks that would cause the 4WD to not enga...

Correctly installs the seal onto the axle shaft and into the wheel knuckle, preventing front hub vacuum leaks that would cause the 4WD to not enga...

This set contains three pitman arm pullers for a wide range of applications from 1993 and later GM, Ford, Dodge and Jeep applications. Includes OT...

Used for removal of the direct injection fuel rail without damage. The rail assembly must be removed as straight as possible to prevent damaging a...

Makes replacing engine drive belts and starter generators easier. This tool compresses the belt tensioner spring during engine drive belt replacem...

Four-piece kit designed to be used with the industry standard OTC No. 7248 C-frame. Contains specialty ball joint adapters to fit the following GM ...

Kit contains two adapters which, when coupled with the large C-frame included in OTC No. 8031 SUV Ball Joint Kit, make it possible to use any adap...

Eight piece kit contains the tools needed to service lower ball joints on 2004-'07 Dodge Sprinter vans Includes tie rod remover/separator wheel al...

Save time removing crankshaft rear seals, preventing damage to the block and crank. This seal remover is a special puller with three jaws designed...

Prevent leaks by properly aligning and installing crankshaft rear seals. This seal installer is a two-piece tool that mounts to the crankshaft and...

The new 6749 Engine Barring Socket; Designed to rotate engine on a Mack E7 and Cat 3208. Similar to J-38587-A.

Ensure replacement injectors and seals are installed correctly. This kit installs the dual seals onto the end of the injector. These seals must be...

Installs the front crank seal with the cover on or off the engine The bolt is threaded into the crankshaft and the nut is tightened to seat the se...

The new 6760 Fuel Filter Wrench is designed to remove and install the fuel filters on the Ford 6.0L & 7.3L Power Stroke diesel engines as well ...

This pair of High Pressure Fuel Rail Adapters is required to connect to the vehicle's fuel line. The fuel line connection changed in 2004 – so the ...

This injector pressure regulator socket actually combines two OE tools into one. Again, the configuration for the IPR changed in 2005 and a second ...

This Terminal Release Tool is required for removal of the vehicle's injector wiring harness without causing damage to the component

Safely remove and install the glow plug harness. For 2004 to 2009 Ford 6.0L Diesel engines. Designed to slip onto the harness caps to safely remov...

Diagnose pressure problems often associated with no starts and help you remove and replace common components like IPR's or EGR's, oil lines, glow ...

Designed for undercar transmission fluid service. All connections are simply press-on quick connects for ease of use. The 6-liter sealed reservoir...