Products

Powerful enough to cut steel, FRP, rubber and resin objects Swivel air inlet and rear air exhaust. Designed with a 0.47" stroke and operates at 5,...

Compact head design allows access into confined areas that normally must be fastened by ahd. Excellent for under-dash, carburetor, body shop repai...

Quiet and powerful solution to removing and installing fasteners 80 ft/lb of torque with a free speed of 200. Weighs only 3.25 lb 12" long

Quiet and powerful solution to removing and installing fasteners 80 ft/lb of torque with a free speed of 200. Weighs only 3.25 lb 12" long

This tool was developed to allow easy removal of injectors on all BMW’s with direct injection. In line 6 cylinder engines our tools is very easy to...

This tool is engineered to improve safety and speed while effectively helping you save time. The patented pitman arm remover is engineered for rem...

This tool is designed to remove the fuel rail pressure sensor on the 2006 to 2010 DURAMAX LBZ and LMM diesel engines. Located in the rear end of t...

This tool is designed to easily remove diesel injectors from 1996 to current VW and Audi vehicles sold in the US market. The TDI injector has a lon...

This three piece 11mm wrench kit has been designed with features specific to each vehicle manufacture BMW, AUDI, and VW that allows the technician...

Release punch tip width and head angle are sized to fit axle keyways providing easy access & leverage required to release the axle nut crimp S...

2 Piece fuel line disconnect wrench set is designed to work on 3/8" VOSS type low pressure fuel line connectors found on Cummins and International...

Holding the water pump pulley while removing the water pump pulley bolts found on 2002 to 2011 Toyota 2.4L 2AZ engines can be challenging. Engine p...

Simplifies valve adjustment on 2004 to 2013 DT466 & MaxxForce International Engines. 13930 & 13940 are both required. Two into One design ...

This unique tool has been developed to aid in the removal and installation of the crank bolt on most Honda an Acura engines. It has been re-engine...

This specially designed four pin tool, with cormoly billet bulkhead pins, is used on vehicles using pressed on pulleys. The four strengthened pins ...

Remove and Install the crank bolt on Lexus/Toyota with ease Works on Lexus 1990 and newer, Toyota 1992 and newer

This harmonic damper pulley holding tool has been developed to aid in the removal and installation of the crank bolt on 3.4L V6 engines. These dam...

This tool has been designed to remove the diesel injectors from Ford vehicles that are equipped with the 6.7L Power Stroke engine. Over time and w...

Allows body shop technicians to hold lift gate or hatch in a partially open position for sanding, painting, buffing or totally open to easily repl...

Accidents Happen - Collision force to one front fender often travels through the hood to push out the top of the opposite fender The Fender Fixer ...

EZ Pull Pliers' gives body shop technicians quick and easy clamping capabilities saving them set-up time over traditional heavy pull clamps and mi...

Foam bumpers protect vehicle finish Spring loaded retractable wheels Extra-wide base 23" Adjustable height 6-1/2 to 22-1/2"

Copper alloy backing plate prevents burn thru (weld will not stick to the copper alloy) Plugweld Pliers allow you to turn up your heat for better ...

Hands free measuring Continuously monitor your pull Measure without an assistant For Body-men, Insurance Adjusters, Fabricators